The firmware allows creating a device with a easily configurable functionality including inputs, outputs, ADC, pulse counter/generator, I2C, external sensors.
I’ve placed all features on the separate page. It is too long.
- The status LED indicator works now.
- The firmware supports up to 8 GPIO inputs or outputs.
- The “switch” mode for inputs.
- Pull-up, Pull-down, Tri-state options for inputs and outputs.
- Analog inputs.
- Internal temperature measurement.
- Source voltage measurement.
- UART (only text commands between an external device and a host, look at README.txt).
- Some environmental sensors (DS18B20, BMP280, BME280, DHT 11, DHT 22, DHT 12, AM2301, Sonoff SI7021,MHZ19, SenseAir S8).
- Not tested: SI7021 (I2C), CCS811.
- Pulse generator.
- Pulse counter (infinite, resettable, interval).
- PWM (hardware 1 MHz).
- PWM (software 1 KHz).
- Bi-stable relay.
- Watchdog timer.
- Configurable default reporting interval.
- Expert options (model ID, manufacturer info, network key, etc.).
Your comments and bug reports are welcome :-)!
2020-05-26 Fixed interview problems in some configurations.
2020-05-21 Increased number of inputs to 8. Configurable TXEN and RXEN pins for the RFX2401 power amplifier. Ability to assign the DS18B20 sensor to an endpoint.
2020-05-03 Added the “Inverse” option for inputs and outputs. Added PWM.
2020-04-22 Fixed internal temperature measurement.
2020-04-20: Fixed problem with a pull-up/down mode. Added checks for pull-up/down settings in the configurator.
2020-04-19: Fixed problem with empty endpoints that may cause problems with joining. Fixed a bug with
2020-04-14: Fixed a problem with ADC