This sensor outputs an analog signal from 0 to 5V. You cannot connect it directly to CC2530, CC2531, CC2652, or CC1352 because they measure up to 3.3V. Therefore, you should use a resistive voltage divider.

Note: The firmware supposes that ACS758 is powered by 5V and used a voltage divider. If the sensor is unidirectional, you must calibrate the zero point (see the corresponding command below).

Type – the sensor type
Frequency and Voltage – parameters of the power source where the sensor is attached.
Monitor output – The GPIO output number defined in the configuration determines whether a load is connected or disconnected. If the selected GPIO output is off, the firmware assumes that no load is connected and that the current should be zero. In this situation, the firmware can initiate a zero calibration procedure to enhance accuracy. Additionally, the firmware reports zero current at this point.

Zigbee2MQTT commands

read - immediately reads the sensor's value.
Topic: zigbee2mqtt/[friedly_name]/get/[channel]
Channel: l1, l2, l3 … l16
Payload: 1
Returns: The counter value {"[channel]": float_value}

write - starts the calibration procedure for the sensor. The power like should be off (current is zero).
Topic: zigbee2mqtt/[friedly_name]/set
Payload: {"[channel]": 0}
Channel: l1, l2, l3 … l16